|Your cart is currently empty|
BM4010 is a strong in-ground car brake tester for light vehicles with axle loads up to 3500kg.
The design of the BM4010 is unique as it allows for split bed installation over an inspection pit.
BM4010 is approved by VOSA / DVSA and is used by both workshops and vehicle inspection bodies.
The brake tester features a long range of options, which allows for a configuration that can meet most customer requirements including:
The BM4010 car brake tester is built to a very high standard in terms of both quality and safety. All exposed steel is hot galvanized to ensure a long lifetime and the wear surface of the rollers is based on mesh steel to ensure long lifetime and accurate measurement. The special roller wear surface also ensures a friction coefficient with both dry and wet tires. It also helps to minimize reduction of the friction coefficient that wear and tear often lead to when using other types of wear surfaces.
As standard the BM4010 is supplied with hot galvanised sub-frames, which are concreted into the ground before the actual brake tester is installed. The sub-frames make the planning and implementation of installations much easier and do also ensure correct alignment of the brake tester during concreting.
The BM4010 can be supplied with a PDA solution, which allows the operator to control and monitor the test results live directly on a PDA unit which communicates wirelessly with the roller brake tester.
Wheel span: 230 to 2230, 880 to 2085 mm, 800 to 2300/2800 mm.
One of the advantages of the BM4010 is that the split bed roller set makes it possible to install over an inspection pit.
After installation the BM4010 is completely flush with the floor. With roller cover plates placed on top of the roller bed, the BM4010 becomes one with the workshop floor making it easy to drive over it from any angle.
BM4010 is as standard supplied with a display having two large analogue dials reading brake force left and right, and a 50mm bright digital readout of brake force imbalance in %.
When configured with Suspension tester and Side slip, the display is delivered with two scales: one for braking force and one for the suspension test, so that all test data can be shown directly in the physical display.
BM4010 can also be supplied with a large display with several digital readouts for e.g. ovality, pedal force, weight, efficiency, suspension values, speed and distance values.
All types of displays can be mounted either on the wall thus saving floor space, or on a floor-mounted column.
The BM4010 can be supplied in a minimum configuration that still allows for a later upgrade to all options.
As standard the BM4010 software allows for advanced graphic printouts enabling the customer to perform both pre inspection brake tests, and diganosis before repair brake tests.
BM can offer a wide range of advanced Windows programs for BM4010. These programs offer storing and presentation of test data, advanced diagnosis tools for processing data and a completely integrated IT solution where all inspection data are collected, stored and printed on one single page.
BM4010 is used by workshops and vehicle inspection bodies. The BM4010 can be delivered with a motor cycle mode which allows for testing of motor cycles and 3 wheel cars.